FLYDUMPS bring you the best Cisco 640-822 exam preparation materials which will make you pass in the first attempt.And we also provide you all the pass4itsure Cisco 640-822 exam updates as Microsoft announces a change in its Cisco 640-822 exam syllabus,we inform you about it without delay.
QUESTION 35
Tom works as a network administrator .Study the exhibit carefully, Tom is resolving a connectivity problem on the serial interfaces. It is known that the serial interface is up and line protocol is down based on the output from the show interfaces command on both routers. Which will be the reason of this problem according to the partial output for the show running-config in the exhibit?
A. The serial cable is bad.
B. The MTU is incorrectly configured.
C. The Layer 2 framing is misconfigured.
D. The IP addresses are not in the same subnet.
Correct Answer: C
QUESTION 36
Jim works as a network administrator for certways Ltd. According to the exhibit below, after configuring two interfaces on the P4S-HQ router, Jim discovers an error message. How to fix this error?
A. The subnet mask of the serial interface should be changed to 255.255.255.0.
B. The serial interface must be configured first.
C. The serial interface must use the address 192.168.1.2.
D. The subnet mask of the FastEthernet interface should be changed to 255.255.255.240.
Correct Answer: D
QUESTION 37
What will happen when computers on a private network try to connect to the Internet via a Cisco router running PAT?
A. The router uses the same IP address but a different TCP source port number for each connection.
B. The router assigns a unique IP address from a pool of legally registered addresses for the duration of the connection.
C. An IP address is assigned based on the priority of the computer requesting the connection.
D. The router selects an address from a pool of one-to-one address mappings held in the lookup table.
Correct Answer: A
QUESTION 38
What source and destination information can you find in the data link layer?
A. port number
B. URL
C. IP address
D. MAC address
Correct Answer: D
QUESTION 39
The global configuration mode on a Cisco router is identified by which prompt?
A. router>
B. router#
C. router(config)#
D. router(config-if)#
Correct Answer: C
QUESTION 40
How many simultaneous Telnet sessions will be supported by a Cisco router by default?
A. 2
B. 3
C. 4
D. 5
Correct Answer: D
QUESTION 41
You are a network technician at P4S, study the exhibit carefully. Host P4S-A has created a communication session with host P4S-B for the first time. What enabled P4S-R1 to transmit this traffic in the correct direction to reach the network to which host P4S-B is attached?
A. TCP/IP
B. a Layer 4 protocol
C. DHCP
D. a routing protocol
Correct Answer: D
QUESTION 42
Which description is correct about the operational state of the FastEthernet 0/0 interface on the basis of the exhibit below?
A. The interface is generating protocol errors.
B. The interface has failed because of a media error.
C. The interface is operational and currently handling traffic.
D. The interface requires a no shutdown command to be issued.
Correct Answer: C
QUESTION 43
Two certways routers are connected as shown below:
certways1 configuration exhibit:
certways2 configuration exhibit:
Two routers named certways1 and certways2 are connected by their serial interfaces as shown in the
exhibit, but there is no data connectivity between them. The certways1 router is known to have a correct
configuration. Given the partial configurations shown in the exhibit, what is the problem on the certways2
router that is causing the lack of connectivity?
A. A loopback is not set.
B. The IP address is incorrect.
C. The subnet mask is incorrect.
D. The serial line encapsulations are incompatible.
Correct Answer: B
QUESTION 44
According to the exhibit below. Information about P4S-RA, including platform and IP addresses, should not be accessible from the Internet due to security reasons. However, this information needs to be accessible to devices on the internal networks of P4S-RA. Which command or series of commands will achieve these goals?
A. P4S-RA(config)#no cdp enable
B. P4S-RA(config)#interface s0/0 P4S-RA(config-if)#no cdp run
C. P4S-RA(config)#no cdp run
D. P4S-RA(config)#interface s0/0 P4S-RA(config-if)#no cdp enable
Correct Answer: D
QUESTION 45
Which will be the result of adding this command to a router already configured for dynamic routing? ip route 0.0.0.0 0.0.0.0 192.168.1.2
A. It configures the router to block routing updates from being sent to IP address 192.168.1.2.
B. It configures the router to drop all packets for which the destination network is unknown.
C. It configures the router as a firewall, blocking all packets from IP address 192.168.1.2.
D. It configures the router to send all packets to IP address 192.168.1.2 if the packets match no other entry in the routing table.
Correct Answer: D
QUESTION 46
Look at the picture: A.
B.
C.
D.
Correct Answer:
QUESTION 47
You are a network technician for certways Ltd. Study the graphic carefully, you are tasked to connect a Cisco router to a Catalyst switch as displayed and you are also working on a computer connected to the management console of the switch. In order to configure the default gateway for the switch, you should learn the IP address of the attached router interface. Which IOS command will provide this information in the absence of Layer 3 connectivity?
A. ping switch_ip_address
B. show ip rarp
C. ping router_ip_address
D. show cdp neighbors detail
Correct Answer: D
QUESTION 48
Which command would configure a default route to any destination network not found in the routing table?
A. P4S-R(config)# ip route 0.0.0.0 255.255.255.255 s0
B. P4S-R(config)# ip default-route 0.0.0.0 s0
C. P4S-R(config)# ip default-route 0.0.0.0 255.255.255.255 s0
D. P4S-R(config)# ip route 0.0.0.0 0.0.0.0 s0
Correct Answer: D
QUESTION 49
According to the exhibit below. P4S-PC1 pings P4S-PC2. Which three things will P4S-CORE router do with the data received from P4S-PC1? (Choose three.)
A. The data frames will be forwarded out interface FastEthernet0/1 of P4S-CORE router.
B. The data frames will be forwarded out interface FastEthernet1/0 of P4S-CORE router
C. P4S-CORE router will place the MAC address of P4S-PC2 in the destination MAC address of the frames.
D. P4S-CORE router will put the MAC address of the forwarding FastEthernet interface in the place of the source MAC address.
Correct Answer: BCD
QUESTION 50
The command ip route 192.168.100.160 255.255.255.224 192.168.10.2 20 was performed on a router. No
routing protocols or other static routes are configured on the router.
Which statement
best describes this command?
A. The interface with IP address 192.168.10.2 is on this router.
B. The command sets a gateway of last resort for the router.
C. Packets that are destined for host 192.168.100.190 will be sent to 192.168.10.2.
D. The number 20 indicates the number of hops to the destination network.
Correct Answer: C
QUESTION 51
Tom is a network technician for the P4S company. Observe the exhibit carefully. He is trying to use
HyperTerminal to configure a new router by use of the settings presented.
Why Tom can’t
connect to the router?
A. The bits per second should be set to 9600.
B. Parity should be set to mark.
C. The stop bits should be set to 2.
D. The data bits should be set to 6.
Correct Answer: A
QUESTION 52
There are three locations in a school district of a large city: P4S-M, P4S-W and P4S-U. The network connection between two of these locations has already functioned. Configure the P4S-M router IP addresses on the E0 and S0 interfaces so that the E0 receives the first usable subnet while the S0 receives the second usable subnet from the network 192.168.160.0/28. Both interfaces would receive the last available IP address on the proper subnet.
A.
B.
C.
D.
Correct Answer:
QUESTION 53
Look at the following exhibit. You are a technician for certways. The configurations in the exhibit are pasted into the two new routers shown. Otherwise, the routers are configured with their default configurations. You cannot ping from P4S-Host1 to P4S-Host2, but you can ping the S0/0 interface of P4S-R2 from P4S-Host1. You have verified the configurations of the hosts and they are correct. What caused the problem?
A. The serial cable on P4S-R1 needs to be replaced.
B. P4S-R1 has no route to the 192.168.1.128 network.
C. The interfaces on P4S-R2 are not configured properly.
D. The IP addressing scheme has overlapping subnetworks.
Correct Answer: B QUESTION 54
In an effort to increase security within the certways wireless network, WPA is being utilized. Which two statements shown below best describe the wireless security standard that is defined by WPA? (Choose two)
A. It specifies use of a static encryption key that must be changed frequently to enhance security.
B. It requires use of an open authentication method.
C. It specifies the use of dynamic encryption keys that change each time a client establishes a connection.
D. It includes authentication by PSK.
Correct Answer: CD QUESTION 55
While moving from one access point to another, which wireless LAN design ensures that a mobile wireless client would not lose connectivity?
A. configuring all access points to use the same channel
B. recommended overlap in cell coverage is 15 to 20%
C. utilizing MAC address filtering to allow the client MAC address to authenticate with the surrounding APs
D. using adapters and access points manufactured by the same company
Correct Answer: B QUESTION 56
Worried about Cisco 640-822 pass results? Adopt most reliable way of exam preparation that is 640-822 Questions & Answers with explanations to get reliable high Cisco 640-822 pass result.Flydumps definitely guarantees it!
